[TheForge] Swedge block question

Tue Apr 22 00:11:01 2003

Not an option. It's only part of one section, the rest of which is the full
3/4" round.

Thanks, though.

Bob

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Steve Smith
Sent: Monday, April 21, 2003 11:22 PM
To: [email protected]
Subject: Re: [TheForge] Swedge block question

Maybe you should start with something smaller diameter and forge it into
the 3/4 round slot. This way you won't have to go to the work of
doubling the length. Half of 3/4 round should be a little larger than
1/2. Try 1/2 and 5/8 and see what strikes your fancy. This will be
*lots* easier. Use a bigger hammer also. Better yet, use a friend with a
sledge.

Steve Smith