[TheForge] Swedge block question

Tue Apr 22 00:29:00 2003

Assuming I only have 3/4" round, what's the most efficient way to forge it to
get the half-round profile?

Forge it to a smaller size first, then use the swedge block?
Peen it in the swedge block from the start?
Other options?

Bob

-----Original Message-----
From: [email protected]
[mailto:[email protected]]On Behalf Of Steve Smith
Sent: Monday, April 21, 2003 11:22 PM
To: [email protected]
Subject: Re: [TheForge] Swedge block question

Maybe you should start with something smaller diameter and forge it into
the 3/4 round slot. This way you won't have to go to the work of
doubling the length. Half of 3/4 round should be a little larger than
1/2. Try 1/2 and 5/8 and see what strikes your fancy. This will be
*lots* easier. Use a bigger hammer also. Better yet, use a friend with a
sledge.

Steve Smith

_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  [email protected]
password:  anvil
___________