[Elecraft] k-pod data cable

[Clay Autery]

That's the way to do it, Jim....

I spent some hours pouring over the docs and MCLR is NOT used in this
implementation.

73,

______________________
Clay Autery, KY5G
MONTAC Enterprises
(318) 518-1389

On 1/16/2017 5:01 PM, Jim Brown wrote:
> If I were to make up an extension using CAT5/6, I would use one pair
> for PGD, another for PGC, and the other two for VCC5, tying the four
> returns of each pair together and wiring it to Ground. I'm taking it
> for granted that MCLR is really unused.
>
> 73, Jim K9YC
>
> On Mon,1/16/2017 10:10 AM, Harry Yingst via Elecraft wrote:
>> A little info for those wanting to make longer cables
>>
>>   As I understand it the Elecraft connector is a Modified MPLAB IDC 2
>> In-Circut Programming connector
>>
>> Here are the pin outs as I read them
>>    1   Unused    - MCLR, Low to reset CPU
>>    2   +5 vDC    - VCC5
>>    3   Ground    - VSS
>>    4   Data      - PGD
>>    5   Clock     - PGC
>>    6   +5 vDC    - VCC5
>>
>> ______________________________________________________________