[Elecraft] K3 Memory Recall - Acting Like Band Select

[Jim - W6VAR]

Thanks, Barry. This should be true if CONFIG: MEM 0-9 is set to BAND SEL, but
I have it set to NOR. In which case, 0-9 should NOT be in the band select
mode and ALL memories should be accessable with M>V ## M>V...unless of
course I missed something in the updates :)

Jim




Barry Simpson wrote:
> 
> Hi Jim
> 
> Memories 0-9 are quick memories which are accessed by the commands M-V and
> then the keypad number. I have programmed each of those memories with each
> band 160 thru 6 metres so that I can change bands without having to use
> the
> up/ down button. I have also programmed the M1 thru M4 buttons to provide
> an
> additional four frequencies in each band. In fact you can program VFO A
> and
> VFO B separately so that in fact with all of the above I have up to nine
> frequencies (each with pre-programmed modes) quickly accessible for each
> band.
> 
> However I digress. To access memories 10 and upwards you simply press the
> M-V command and then rotate the VFO A knob to get to the memory number you
> require. To program a memory with the current VFO A frequency, mode and
> selectivity you need to use the V-M command and then either press the
> keypad
> number to be programmed (0 thru 9) or rotate VFO A for memories 10 and
> upwards to select the number you want and then press V-M again. 
> 
> I hope this helps.
> 
> 73
> 
> Barry Simpson  VK2BJ
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 
:-/:-/
-- 
View this message in context: http://n2.nabble.com/K3-Memory-Recall---Acting-Like-Band-Select-tp2017818p2019187.html
Sent from the Elecraft mailing list archive at Nabble.com.