[Elecraft] K3 Memory Recall - Acting Like Band Select

[Barry Simpson]

Hi Jim

Memories 0-9 are quick memories which are accessed by the commands M-V and
then the keypad number. I have programmed each of those memories with each
band 160 thru 6 metres so that I can change bands without having to use the
up/ down button. I have also programmed the M1 thru M4 buttons to provide an
additional four frequencies in each band. In fact you can program VFO A and
VFO B separately so that in fact with all of the above I have up to nine
frequencies (each with pre-programmed modes) quickly accessible for each
band.

However I digress. To access memories 10 and upwards you simply press the
M-V command and then rotate the VFO A knob to get to the memory number you
require. To program a memory with the current VFO A frequency, mode and
selectivity you need to use the V-M command and then either press the keypad
number to be programmed (0 thru 9) or rotate VFO A for memories 10 and
upwards to select the number you want and then press V-M again. 

I hope this helps.

73

Barry Simpson  VK2BJ