[Elecraft] ATU P6/J7 alignment

[K4IA at aol.com]

It's the old P6/J7 question again.  I found some references in the  archives 
but they just say "Wow, be careful" or  "I once was lost but  now I'm saved." 
without actually telling how it goes.
 
So can someone help me get this straight?
 
If I wire J7 as shown on page 10 of the manual and install P6 so the  locking 
tab is to the front of the radio, the braid ends up in the connector  that is 
closest to the edge of the radio.  But, it looks like the ground  side is the 
one closest to the center of the radio not the edge.  In other  words, either 
the drawing on page 10 is backwards or the locking tab has to be  to the back 
of the radio or
 
I JUST DON'T GET IT!
 
Comments?
 
Radio  k4ia
"Buck"
Fredericksburg, Virginia  USA