[TheForge] filling pipe with sand to bend

[Kim George]

Anyone try using more than one piece of cable? Taking smaller dia.
cable to fill the volume.

On 11/7/12, John Allen <countrymetals at gmail.com> wrote:
> I have needed this done for the food industry with sanitary piping, I ended
> up getting a mechanic shop with an exhaust bender to bend it. They say that
> it wont do it but if the bend isn't too bad like the 42" rad then it should
> be fine. Plus they are normally better at gauging a bend if it is a normal
> muffler shop because they do it often. The down side is that your pipe is
> smaller and they might not have the dies.
>
> --
> John Allen
> Country Metals, LLC
> (856) 542-4316 (cell)
> (856) 504-0087 (fax)
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.photoworks.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>


-- 
Kim George

"Why for you try to bury me in cold,cold ground?"
     Taz