[TheForge] press design

[Mark A. Pesetsky]

Well I have branched out to sculptural work now that has us working 2"X4" stock and above. So we need quite a bit of force.
________________________________________
From: theforge-bounces at mailman.qth.net [theforge-bounces at mailman.qth.net] on behalf of James Binnion [jbin at well.com]
Sent: Saturday, March 19, 2011 11:15 AM
To: Blacksmithing List Sponsored by ABANA
Subject: Re: [TheForge] press design

I might suggest that you think about finding a 3000 psi pump and use that to drive your cylinder. Much faster and if you are forging small stock like knives and such the 30 tons you would get would be just fine.

Jim

On Mar 19, 2011, at 7:59 AM, Mark A. Pesetsky wrote:

> The press on the right found on this page:
>
> http://www.dfoggknives.com/pressgallery.htm
>
> I have an ENERPAC air over hydraulic pump system w/their 100 ton cylinder.
>

James Binnion
jbin at well.com



______________________________________________________________
TheForge mailing list
Home: http://mailman.qth.net/mailman/listinfo/theforge
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:TheForge at mailman.qth.net

TheForge mail list group photo site is
http://www.photoworks.com
Login: blacksmithblacksmith at hotmail.com
Password: anvil

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html