[TheForge] press design

[James Binnion]

I might suggest that you think about finding a 3000 psi pump and use that to drive your cylinder. Much faster and if you are forging small stock like knives and such the 30 tons you would get would be just fine.

Jim

On Mar 19, 2011, at 7:59 AM, Mark A. Pesetsky wrote:

> The press on the right found on this page:
> 
> http://www.dfoggknives.com/pressgallery.htm
> 
> I have an ENERPAC air over hydraulic pump system w/their 100 ton cylinder.
> 

James Binnion
jbin at well.com