[TheForge] drilling angles

[Woolley]

Endmill?  Slow easy start





Andy Gladish wrote:
> Slap me if I've asked this already, but this forum seems to be the best  
> bet for getting feedback of any I've found out there...
> Anyone care to walk me through drilling angled holes? I've tried pilot  
> holes of various kinds, but I set up the drill press at 34 deg, and can't  
> figure out how to get the 1/2" bit started so it digs in in exactly the  
> right place- drilling an approximate hole isn't that hard, drilling an  
> accurate one is so far impossible. The bit wants to wander off down hill  
> no matter what I"ve done.
> Signed,
> Stumped in Seattle
> ______________________________________________________________
> TheForge mailing list
> Home: http://mailman.qth.net/mailman/listinfo/theforge
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:TheForge at mailman.qth.net
>
> TheForge mail list group photo site is
> http://www.photoaccess.com
> Login: blacksmithblacksmith at hotmail.com
> Password: anvil
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>