[TheForge] drilling question

[Larry Brown]

Figure out what your offset is and drill from each side then hand drill 
between the holes to get the angles like a reamer. Make a easy drill guide, 
hole with pin or rivet and where you want the next hole. If you have a lot 
of holes to drill, make several of the guides at the beginning of the job 
not from each other after they are worn.
L Brown


>Andy Gladish wrote:
> > Thanks Ries and Andy, lots to go on there.
> > It's a little off topic cause there's not a forged scrap in this railing,
> > and I don't get to choose whether it's drilled or not...
> > I'll try the jig if just drilling and reaming won't do it. Fortunately,
> > the holes go in square tube rather than solid, so it's easier to abuse
> > that way.
> > Andy G.