[TheForge] Band saw blades

[Ron Childers]

Holly is local; we used to have a half dozen industrial supply places here,
any one of which could make up blades. The neat setup is an electric spot
welder made for the purpose of welding band saw blades.

Ron C 

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of PlumDon at aol.com
Sent: Thursday, March 06, 2008 4:55 PM
To: theforge at mailman.qth.net
Subject: Re: [TheForge] Band saw blades

In a message dated 3/6/2008 7:38:22 AM Eastern Standard Time,  
mobjak at yahoo.com writes:
Did you check Enco?  They are typically less  expensive
(of course most companies are) than McMaster Carr.
 

Thanks for the info re bandsaw blades,folks. Enco did not have the size  and

no Holly, Inc nearby. But I did find a source a bit cheaper than McMaster
and 
the same size, etc., that Jim recommended: Sunbelt  Industrial 
 
A while ago there was some discussion on glass doors for fireplace screens.

I think even some notes about how to and technique. Did anyone, perchance, 
keep  those notes and could pass them back to me. 
 
Kindest thanks
 
Don Plummer



**************It's Tax Time! Get tips, forms, and advice on AOL Money & 
Finance.      (http://money.aol.com/tax?NCID=aolprf00030000000001)
_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________