[TheForge] Band saw blades

[robert hensarling]

One other source you may check is Carter.  For years they just specialized
in bandsaw bearings and guides.  They're all I use on my 3 bandsaws.  They
even fixed me up on my 1914 Oliver 36".  They have any size tire you may
need, plus either rubber cement for wheels 20" and under, and epoxy for 20+
up to 42", that's a lot of tire!  They are also carrying large wheels for
some of the big guys, 36" to 42"
Good luck with your project, let us know what you ended up doing.
 Carter's number is 1-888-622-7837, or
www.carterproducts.com
One last thing that some of you may like, I sure do;  They carry a full line
of laser beam equipment.
Robert

----- Original Message ----- 
From: <PlumDon at aol.com>
To: <theforge at mailman.qth.net>
Sent: Thursday, March 06, 2008 3:54 PM
Subject: Re: [TheForge] Band saw blades


> In a message dated 3/6/2008 7:38:22 AM Eastern Standard Time,
> mobjak at yahoo.com writes:
> Did you check Enco?  They are typically less  expensive
> (of course most companies are) than McMaster Carr.
>
>
> Thanks for the info re bandsaw blades,folks. Enco did not have the size
and
> no Holly, Inc nearby. But I did find a source a bit cheaper than McMaster
and
> the same size, etc., that Jim recommended: Sunbelt  Industrial
>
> A while ago there was some discussion on glass doors for fireplace
screens.
> I think even some notes about how to and technique. Did anyone, perchance,
> keep  those notes and could pass them back to me.
>
> Kindest thanks
>
> Don Plummer
>
>
>
> **************It's Tax Time! Get tips, forms, and advice on AOL Money &
> Finance.      (http://money.aol.com/tax?NCID=aolprf00030000000001)
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>