[TheForge] Anvil

[Washington, Aubrey O.]

1.27 times heavier.
 

________________________________

From: theforge-bounces at mailman.qth.net on behalf of Ron Childers
Sent: Tue 3/27/2007 12:26 PM
To: 'Sponsored by ABANA'
Subject: RE: [TheForge] Anvil



Doesn't matter- But remember, 6" sq is heavier than 6" rnd

-----Original Message-----
From: theforge-bounces at mailman.qth.net
[mailto:theforge-bounces at mailman.qth.net] On Behalf Of Phil
Sent: Tuesday, March 27, 2007 1:16 PM
To: Sponsored by ABANA
Subject: Re: [TheForge] Anvil


Mark:

I think most folks use round stock, it seems to be
more abundant in those larger sizes.  I would use what
ever you can get your hands on, is not too expensive,
and has enough mass.

Phil
--- "Mark A. Pesetsky" <pesetsky at Princeton.EDU> wrote:

> 
>
>
> I am a PIA but I want to know what those more
> experienced with these
> hammers think about certain aspects of building one
> before I order the
> parts....
>
> Round stock or square on the anvil? I am about to
> place the order for
> this piece of steel as well as the rest of the
> steel...hammer
> head...etc....
>
> Also, at what point in the stroke of the air
> cylinder do you want the
> hammer head to meet the die? If the stroke is 12"
> would the contact be
> at the 8-10" point on the stroke?
>
> Thanks Again Guys
> Mark
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is http://www.photoaccess.com <http://www.photoaccess.com/> 
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>




____________________________________________________________________________
________
Finding fabulous fares is fun. 
Let Yahoo! FareChase search your favorite travel sites to find flight and
hotel bargains. http://farechase.yahoo.com/promo-generic-14795097
_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is http://www.photoaccess.com <http://www.photoaccess.com/> 
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________



_______________________________________________
Manage membership or unsubscribe at:
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com <http://www.photoaccess.com/> 
Login:  blacksmithblacksmith at hotmail.com
password:  anvil
___________