[TheForge] PIA Anvil

[dann at wctatel.net]

Hmmm ...


I tried googling words -  pia blacksmith - and got

"PIA LEADS CALL TO SAVE MARILAO RIVER: Senate environment committee
chairperson Sen. Pia S. Cayetano and Blacksmith Int'l Representative Marlo
Mendoza survey the heavily polluted Marilao-Meycauayan-Obando River System
in Bulacan during an ocular visit last January 10. Cayetano has been
leading a campaign to revive the river, which was the site of one of last
year's worst toxic dumping cases."
<http://www.senate.gov.ph/photo_release/2007/0111_01.asp>

I speak a bit of Spanish, and knew that Pia is a woman's name, but this
was about a Philippines Senator named Pia.

If I don't ask, I remain as ignorant as I was yesterday.

Help ?

Dann



>
>
>
> I am a PIA but I want to know what those more experienced with these
> hammers think about certain aspects of building one before I order the
> parts....
>
> Round stock or square on the anvil? I am about to place the order for
> this piece of steel as well as the rest of the steel...hammer
> head...etc....
>
> Also, at what point in the stroke of the air cylinder do you want the
> hammer head to meet the die? If the stroke is 12" would the contact be
> at the 8-10" point on the stroke?
>
> Thanks Again Guys
> Mark
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>