[TheForge] Project advice

[Bruce Freeman]

Bob,
I'm not sure we're communicating.
I was taught, and I teach, that you take any bar to
square (though hex works too) and forge it as far as
necessary.  If you want it round, you THEN go to
octagonal then round.  That's what I mean by SOR.
Bruce

--- schade at acegroup.cc wrote:

> 
> On Jun 17, 2007, at 7:56 AM, Bruce Freeman wrote:
> >  (noting that 'SOR'
> > does NOT apply to pipe),
> 
> 
> I never "SOR" anyway. I just go straight to "S" and
> draw away. I think 
> "SOR" might have some good reasons if forging 3"
> stock but for forging 
> 3/4" and down to a smaller size "SOR" seems a waste
> of time. BTW I am 
> using a powerhammer.
> 
> Bob
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 




 
____________________________________________________________________________________
Need Mail bonding?
Go to the Yahoo! Mail Q&A for great tips from Yahoo! Answers users.
http://answers.yahoo.com/dir/?link=list&sid=396546091