[TheForge] Plate for my post vise

[Mike Linn]

I built a tripod for my 4 inch vise. Its stable, ( if I need more stability 
I stand on the chain) and its portable. It will also fold up so I can stand 
it in a corner when not in use.

Ive posted the photos to the photoaccess site under vises if your 
interested..

mike

At 05:03 PM 11/14/2006, you wrote:
>I need a thicker plate for my 51/2” post vise. Currently I have a ¼” piece.
>My friend found a ¾” piece that is 22x18. I want to make it round so I can
>roll it. I was just going to weld the ¼” on to the ¾” for a total of 1”.
>Would a 1” piece that is 18” dia be heavy enough so it will not move all
>around?
>
>
>Thanks
>
>Martin


            Mike Linn
      Artist Blacksmith
          McCalla, AL
        AFC Webmaster
http://afc.abana-chapter.com

______________________________________________________________________

"Many of life's failures are people who did not realize how
   close they were to success when they gave up. "
   ~ Thomas A. Edison
______________________________________________________________________