[TheForge] Drilling holes in rods

[PlumDon at aol.com]

Looking for a technique or jig design to drill  multiple 1/8" holes  
accurately  
through the center of 3/8" round. This is for 1/8" spokes  for a 6" wheel. I  
could 
drill before shaping into a wheel or after  bending to a circle. ( I  
recognize 
I would have to re-drill after  bending). I only have drill press  and hand 
drills available to do the  job. Any suggestions much appreciated. 

Regards

Don   Plummer
Plummer Design Works
392 Hallman Mill Road
Phoenixville,  PA  19460
610-495-5058