[TheForge] local source of ITC 100

[PlumDon at aol.com]

Looking for a technique or jig design to drill a 1/8" hole accurately  
through the center of 3/8" round. This is for 1/8" spokes for a 6" wheel. I  could 
drill before shaping into a wheel or after bending to a circle. ( I  recognize 
I would have to re-drill after bending). I only have drill press  and hand 
drills available to do the job. Any suggestions much appreciated. 
 
Regards
 
Don  Plummer
Plummer Design Works
392 Hallman Mill Road
Phoenixville, PA  19460
610-495-5058