[TheForge] Drill Press

[Dan Tull]

I believe  :~)  the chuck on the sears has the shaft built on.

A jt33 is going to fit the hole in the drillpress.
Get an Albrecht that has a jt33 shaft. Or am I missing something?



dan tull
georgia
abba, afc, S.C. psba, obg,sofa
----- Original Message ----- 
From: "Steve Smith" <sos at alum.mit.edu>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Wednesday, October 20, 2004 7:11 PM
Subject: Re: [TheForge] Drill Press


> Your words are too few for me to guess what the confusion is. What I'm 
> saying is that the chuck end of his arbor is JT33, while the drill press 
> end is something else (likely MT2). What made me write this was Mark's 
> comment:
> 
> "Yep JT 33....So now all I need to find out is the diameter of the hole 
> in the ALBRECHT and order a JT33 to fit that?"
> 
> The way I read this, it sounds like Mark thought his drill press was 
> JT33, and all he needed to know was the taper size in the Albrecht. I 
> thought this worth commenting on, since the JT33 refers to the chuck not 
> the drillpress.
> 
> Steve
> 
> 
> Dan Tull wrote:
> 
>> HUH?
>> dan tull
>> georgia
>> abba, afc, S.C. psba, obg,sofa
>> ----- Original Message ----- From: "Steve Smith" <sos at alum.mit.edu>
>> To: "Sponsored by ABANA" <theforge at mailman.qth.net>
>> Sent: Tuesday, October 19, 2004 6:01 PM
>> Subject: Re: [TheForge] Drill Press
>> 
>> 
>>> I think the JT33 means the taper of the chuck, not the drill press. 
>>> Since the arbor is changeable, there wouldn't be any sense in having 
>>> its size stamped on the chuck.
>>>
>>> Steve
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
>