[TheForge] engineering question

[Dan Tull]

The question should designate "stronger" in which force, tension, 
bending,shear,etc.


dan tull
georgia
abba, afc, S.C. psba, obg,sofa
----- Original Message ----- 
From: "Mike Linn" <bamablacksmith at comcast.net>
To: "Sponsored by ABANA" <theforge at mailman.qth.net>
Sent: Friday, October 01, 2004 7:42 PM
Subject: Re: [TheForge] engineering question


>
> I would say on the diamond would be stronger because on the square would 
> put the corner closer to the edge. and thus thinner, though I think the 
> difference would be minor depending on the direction of the forces.
>
>
> mike
>
>
>
> At 01:51 PM 10/1/2004, you wrote:
>>In slitting and drifting a square hole,
>>since no metal is lost,
>>will it make a difference in strength if the hole is square to the side
>>or on the diamond?
>>
>>
>>dan tull
>>georgia
>>abba, afc, S.C. psba, obg,sofa
>>_______________________________________________
>>Manage membership or unsubscribe at:
>>http://mailman.qth.net/mailman/listinfo/theforge
>>theforge mail list group photo site is
>>http://www.photoaccess.com
>>Login:  blacksmithblacksmith at hotmail.com
>>password:  anvil
>>___________
>
>
>            Mike Linn
>      Artist Blacksmith
>          McCalla, AL
>        AFC Webmaster
> http://afc.abana-chapter.com
>
>
> "Don't worry Chief, I can stand the torture if they can stand the 
> screaming."
>                                              - Maxwell Smart, Secret Agent 
> 86
>
>
> ______________________________________________________________________
>
>
>
>
>
>
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
>
>
>