[TheForge] Re: Powder Damascus

[Andrew Vida]

Steel shot makes a fabulous honeycomb pattern.  The one's I've seen were 
about 1/4".  250 seems a bit tight.  Is there a specific reason to use 
such small shot?

Chuck Robinson wrote:
> You can get powder from Jeff Carlisle
> 1-406-452-1246 Carlisle Supplies
> I'm also looking into a source for 250 mesh steel shot. Will know more in
> February.
> Chuck
> ----- Original Message -----
> From: "Doug Ayen" <ayen at homeport.org>
> To: "Sponsored by ABANA" <theforge at mailman.qth.net>
> Sent: Friday, December 10, 2004 3:17 PM
> Subject: Re: [TheForge] Re: Powder Damascus
> 
> 
> 
>>Anyone have a good source for powdered steel? this sounds intriguing. :)
>>
>>--doug
>>_______________________________________________
>>Manage membership or unsubscribe at:
>>http://mailman.qth.net/mailman/listinfo/theforge
>>theforge mail list group photo site is
>>http://www.photoaccess.com
>>Login:  blacksmithblacksmith at hotmail.com
>>password:  anvil
>>___________
>>
>>
>>
> 
> 
> 
> _______________________________________________
> Manage membership or unsubscribe at:
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  blacksmithblacksmith at hotmail.com
> password:  anvil
> ___________
> 
> 
> 
>