[TheForge] NEW - weld question

[Mark Pesetsky]

I have a LINCOLD Weld-Pak 155 and I was wondering if I could weld some 1/4"
"I" beam to a mild plate w/o a gas conversion using flux core welding wire.
Is this something that could be done with a strong enogh weld for the air
hammer that I am building?

The specs for the said welder are as follows:


Welding Specifications
Rated CV Output Amps/Volts/Duty Cycle Output Range Wire Feed Speed Range
(IPM) Wire Feed Speed Range (M/MIN) Solid Wire Size Range Cored Wire Size
Range
208V: 130/20/25%
230V: 130/20/30% 30-175A DC 50-400 1.3-10.2 .025-.035" .035-.045"


Thanks In Advance
Mark