[TheForge] welding 1 1/2" square

Thu Jan 24 14:05:00 2002

Thanks. If I had it to do over again I think I would use larger diameter
rods, but there you go.
Ray

-----Original Message-----
From: Larry [mailto:[email protected]]
Sent: Thursday, January 24, 2002 11:43 AM
To: [email protected]
Subject: Re: [TheForge] welding 1 1/2" square

The table is nice also.  ;-)

"Miller, Ray (GEAE)" wrote:

> Sorry to mislead. The decorations on top of the table were provided by the
> interior designer. This was in a Homearama house that sold for
$850,000!!!!
> Ray
>
> -----Original Message-----
> From: Larry [mailto:[email protected]]
> Sent: Thursday, January 24, 2002 9:27 AM
> To: [email protected]
> Subject: Re: [TheForge] welding 1 1/2" square
>
> Nice work Ray, I really like the urn on the table, did you do that by
> spinning?
>
> Larry
>
> "Miller, Ray (GEAE)" wrote:
>
> >
> > http://www.uc.edu/profiles/rmiller.htm
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://www.photoaccess.com
> Login:  [email protected]
> password:  anvil
> ___________

_______________________________________________
http://mailman.qth.net/mailman/listinfo/theforge
theforge mail list group photo site is
http://www.photoaccess.com
Login:  [email protected]
password:  anvil
___________