[TheForge] (no subject)

Wed Dec 12 02:29:00 2001

Thats 150mm long not 15mm

----- Original Message -----
From: "Shannell" <[email protected]>
To: <[email protected]>
Sent: Wednesday, December 12, 2001 2:28 PM
Subject: Re: [TheForge] (no subject)


> I use angle iron for a lot of my hardy stems
> heavy stuff works best say 5 mm wall 30x30 or so
> I cut a piece say 15mm long and flatten one end a little so that end no
> longer fits through the hardy, then I hammer it in till the flared part of
> the angle iron is level with the face of the anvil, this will set the
"fit"
> ,you can open it up a little to make it a firmer fit
> then just weld this onto the bottom of your tool
> Im sure others do it this way too but I thought it was a pretty simple and
> good idea
>
> ----- Original Message -----
> From: "Steve Smith" <[email protected]>
> To: <[email protected]>
> Sent: Wednesday, December 12, 2001 1:24 PM
> Subject: Re: [TheForge] (no subject)
>
>
> > I didn't have to sleeve mine, but the problem I have making hardy stems
> > might apply. My hardy hole (1.25") is tapered on my 246lb Peter Wright.
> > This makes using square tubing for a stem useless. I generally need to
> > do a fair bit of grinding and fitting when I make a hardy tool.
> >
> > Steve Smith
> >
> > Frederick Faller wrote:
> >
> > > I have just installed my new old anvil and am
> > > chagrinned that the hardie hole is 1.25" rather than
> > > the 1.0" hole I have in my Peter Wright. Is it
> > > reasonable to make an adapter so I don't have to make
> > > all my hardie tools over again? If so, any suggestions
> > > would be appreciated.
> > >
> > > Frederick Faller
> > >
> > > __________________________________________________
> > > Do You Yahoo!?
> > > Check out Yahoo! Shopping and Yahoo! Auctions for all of
> > > your unique holiday gifts! Buy at http://shopping.yahoo.com
> > > or bid at http://auctions.yahoo.com
> > > _______________________________________________
> > > http://mailman.qth.net/mailman/listinfo/theforge
> > > theforge mail list group photo site is
> > > http://albums.photopoint.com/j/AlbumList?u=1169182
> > > ___________
> >
> > _______________________________________________
> > http://mailman.qth.net/mailman/listinfo/theforge
> > theforge mail list group photo site is
> > http://albums.photopoint.com/j/AlbumList?u=1169182
> > ___________
> >
> >
> >
>
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://albums.photopoint.com/j/AlbumList?u=1169182
> ___________
>
>
>