[TheForge] (no subject)

Sat Dec 15 11:45:59 2001

        Fred, I use a piece of angle iron that goes to my anvil stand and up
to the hardy hole, works great........tubing is often too thick.

Ralph


----- Original Message -----
From: "Frederick Faller" <[email protected]>
To: "NEBlist" <[email protected]>; "The forge list"
<[email protected]>
Sent: Tuesday, December 11, 2001 2:42 PM
Subject: [TheForge] (no subject)


> I have just installed my new old anvil and am
> chagrinned that the hardie hole is 1.25" rather than
> the 1.0" hole I have in my Peter Wright. Is it
> reasonable to make an adapter so I don't have to make
> all my hardie tools over again? If so, any suggestions
> would be appreciated.
>
> Frederick Faller
>
> __________________________________________________
> Do You Yahoo!?
> Check out Yahoo! Shopping and Yahoo! Auctions for all of
> your unique holiday gifts! Buy at http://shopping.yahoo.com
> or bid at http://auctions.yahoo.com
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://albums.photopoint.com/j/AlbumList?u=1169182
> ___________
>
>