[TheForge] (no subject)

[Steve Smith]

I didn't have to sleeve mine, but the problem I have making hardy stems
might apply. My hardy hole (1.25") is tapered on my 246lb Peter Wright.
This makes using square tubing for a stem useless. I generally need to
do a fair bit of grinding and fitting when I make a hardy tool.

Steve Smith

Frederick Faller wrote:

> I have just installed my new old anvil and am
> chagrinned that the hardie hole is 1.25" rather than
> the 1.0" hole I have in my Peter Wright. Is it
> reasonable to make an adapter so I don't have to make
> all my hardie tools over again? If so, any suggestions
> would be appreciated.
>
> Frederick Faller
>
> __________________________________________________
> Do You Yahoo!?
> Check out Yahoo! Shopping and Yahoo! Auctions for all of
> your unique holiday gifts! Buy at http://shopping.yahoo.com
> or bid at http://auctions.yahoo.com
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://albums.photopoint.com/j/AlbumList?u=1169182
> ___________