[TheForge] (no subject)

Tue Dec 11 20:45:01 2001

.090-wall X1.25" square tubing for a loose fit. .125-wall X 1.25" square
tubing for a tight fit. :)

You may have to grind the outside a bit for slip fit in the hardy hole. By
shimming with square tubing like this, you can make the tools fit decently
in either anvil's hardy hole.

----- Original Message -----
From: "Frederick Faller" <[email protected]>
To: "NEBlist" <[email protected]>; "The forge list"
<[email protected]>
Sent: Tuesday, December 11, 2001 2:42 PM
Subject: [TheForge] (no subject)

> I have just installed my new old anvil and am
> chagrinned that the hardie hole is 1.25" rather than
> the 1.0" hole I have in my Peter Wright. Is it
> reasonable to make an adapter so I don't have to make
> all my hardie tools over again? If so, any suggestions
> would be appreciated.
>
> Frederick Faller
>
> __________________________________________________
> Do You Yahoo!?
> Check out Yahoo! Shopping and Yahoo! Auctions for all of
> your unique holiday gifts! Buy at http://shopping.yahoo.com
> or bid at http://auctions.yahoo.com
> _______________________________________________
> http://mailman.qth.net/mailman/listinfo/theforge
> theforge mail list group photo site is
> http://albums.photopoint.com/j/AlbumList?u=1169182
> ___________
>
>
>