[Test-Equipment] Source for Fluke 25/27 DMM parts? ADDENDUM

[Barry]

Yes.  Without a P/N, they coulddn't help.  I can find the Service Manual for the Model 27 but not the 25.  I thought the housings were the same and the 27 shows a separate piece for the bezel; however, when I disassembled my Model 25, the bezel is a single piece of plastic that is somehow bonded to the housing.  I think the only way to fix it is to replace the housing and those are not easy to find  :(

Thanks for the reply,
Barry - N4BUQ


 On Sat 05/05/12  8:24 AM , ma.locksmith at juno.com sent:
> Have you already tried Fluke?
> 
> Ed
> 
> On Fri, 4 May 2012 22:46:41 -0400 Barry n4buq at knolo
> gy.net> writes:> Well, I dug into it and that lens is pretty much
> permanently bonded > to the frame.  I tried quite forcebly to push it
> out and it didn't > budge.  I'm just about sure it will break if I try
> to force it any > more.
> > 
> > I scraped the excess plastic (lexan?) and then
> tried to polish it > but Novus Plastic Polish #2 doesn't touch it.  I
> suppose I'm stuck > with leaving it like it is unless someone has some
> experience > replacing this.
> > 
> > Thanks,
> > Barry - N4BUQ
> > 
> 
> 
>