[Test-Equipment] Source for Fluke 25/27 DMM parts? ADDENDUM

[Bill Fuqua]

   Is it possible that the solvent dissolved and glued the plastic pieces 
together?
I can't see why they should be one piece.
Bill

At 10:00 AM 5/5/2012 -0400, Barry wrote:
>Yes.  Without a P/N, they coulddn't help.  I can find the Service Manual 
>for the Model 27 but not the 25.  I thought the housings were the same and 
>the 27 shows a separate piece for the bezel; however, when I disassembled 
>my Model 25, the bezel is a single piece of plastic that is somehow bonded 
>to the housing.  I think the only way to fix it is to replace the housing 
>and those are not easy to find  :(
>
>Thanks for the reply,
>Barry - N4BUQ
>
>
>  On Sat 05/05/12  8:24 AM , ma.locksmith at juno.com sent:
> > Have you already tried Fluke?
> >
> > Ed
> >
> > On Fri, 4 May 2012 22:46:41 -0400 Barry n4buq at knolo
> > gy.net> writes:> Well, I dug into it and that lens is pretty much
> > permanently bonded > to the frame.  I tried quite forcebly to push it
> > out and it didn't > budge.  I'm just about sure it will break if I try
> > to force it any > more.
> > >
> > > I scraped the excess plastic (lexan?) and then
> > tried to polish it > but Novus Plastic Polish #2 doesn't touch it.  I
> > suppose I'm stuck > with leaving it like it is unless someone has some
> > experience > replacing this.
> > >
> > > Thanks,
> > > Barry - N4BUQ
> > >
> >
> >
> >
>
>______________________________________________________________
>Test-Equipment mailing list
>Home: http://mailman.qth.net/mailman/listinfo/test-equipment
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Test-Equipment at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html