[Test-Equipment] Source for Fluke 25/27 DMM parts? ADDENDUM

[Mike Manes]

I'd start with a coarse an abrasive as necessary to get down to a
smooth surface, even sandpaper, and then work down to finer and finer
abrasives to wear off the scratches from the previous work.  Just be
careful NOT to work the material too hard, since it will melt if it
gets too hot.  Keeping the abrasive wet with water can help prevent
this problem.
73 de Mike W5VSI

On 5/5/2012 12:17, Howie wrote:
> Jewelers rouge.
>
> Auto polishing compound like turtle wax.
>
> Brasso.
>
>
> ----- Original Message -----
> From:<ma.locksmith at juno.com>
> To:<n4buq at knology.net>;<test-equipment at mailman.qth.net>
> Sent: Saturday, May 05, 2012 9:24 AM
> Subject: Re: [Test-Equipment] Source for Fluke 25/27 DMM parts? ADDENDUM
>
>
>> Have you already tried Fluke?
>>
>> Ed
>>
>> On Fri, 4 May 2012 22:46:41 -0400 Barry<n4buq at knology.net>  writes:
>>> Well, I dug into it and that lens is pretty much permanently bonded
>>> to the frame.  I tried quite forcebly to push it out and it didn't
>>> budge.  I'm just about sure it will break if I try to force it any
>>> more.
>>>
>>> I scraped the excess plastic (lexan?) and then tried to polish it
>>> but Novus Plastic Polish #2 doesn't touch it.  I suppose I'm stuck
>>> with leaving it like it is unless someone has some experience
>>> replacing this.
>>>
>>> Thanks,
>>> Barry - N4BUQ
>>>
>> ______________________________________________________________
>> Test-Equipment mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/test-equipment
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Test-Equipment at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> Test-Equipment mailing list
> Home: http://mailman.qth.net/mailman/listinfo/test-equipment
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Test-Equipment at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>

-- 
Mike Manes    mrmanes at gmail.com     Tel: 303-979-4899
"Things should be made as simple as possible, but not more so."
A. Einstein