[TenTec] Need help with 535/536 address selection

[howard wilson]

Have used the Argonaut 2 with model 305 level converter successfully. My
address is set to 64 and is changed by pressing the function and mode
keys and then using the up/down keys to modify the address.

73, Howie wa2ncf at juno.com

On Mon, 17 Oct 2005 17:19:56 -0600 "Augie (Gus) Hansen"
<augie.hansen at comcast.net> writes:
> Has anyone successfully used the Argonaut II (or Delta II) with the 
> model
> 305 level converter? The 305 (electrically equivalent to the Icom 
> CT-17)
> works fine with my Icom radios, but I'm having a problem getting it 
> to work
> with my Argonaut II.
> 
> The problem is that I can't set the address selection code in the
> transceiver because the documents provided with the 535 and the 305 
> refer to
> each other, but neither provides the information needed to set the 
> value.
> The 535 Quick Reference Card says to press the "F" button followed 
> by the
> "<MODE" button to view/set the code. Doing so displays a value of 
> EC.000.1
> (the factory preset is supposed to be 64). Does anyone know the 
> secret to
> changing this value? The card says "See the manual for further 
> information",
> which turns out to be a wild pointer to nowhere.
> 
> For those of you ready to suggest that I call Ten-Tec Service for 
> help, I
> already did. Paul tried to be helpful, but wasn't, beyond confirming 
> that
> the 1/8" connector on the rear panel labeled REMOTE is, in fact, the 
> serial
> interface port (which is labeled J-3 on the Delta II).
> 
> Gus Hansen 
> KB0YH
> 
> _______________________________________________
> Tentec mailing list
> Tentec at mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/tentec
>