[TenTec] Suggestion for Argonaut V

[John Rippey]

In using the Argonaut V, I have found working split is less than ideal. 
Here are some suggestions.

One improvement would be for the tuning dial "LOCK" feature to affect only 
one VFO at a time. (This may not be possible due to the VFO circuitry 
Ten-Tec utilizes.) At any rate, VFO "A" could be locked onto the DX 
station's sending frequency while VFO "B" would be free and used to select 
a second frequency from which to call the DX station. With the present 
set-up, it's too easy to move the tuning dial, hence frequency, when 
switching back and forth between VFO's and lose either the DX station's 
sending frequency or a good spot to make a call.

Another way to go about a better split operation would be to modify the 
RIT/XIT configuration in two ways:

	1. Make the "RIT" button toggle on and off so successive presses would 
take you to the VFO's frequency (which could be locked onto the DX 
station's sending frequency) and back again to the RIT frequency. As it is, 
the RIT frequency readout disappears when the "RIT" button is pressed, but 
the receiver stays put on that frequency. (A longer press of the "RIT" 
button erases the RIT frequency entirely.)

	2. Make it an option for the XIT frequency to track the RIT frequency. 
This change would enable you to send instantly from the RIT frequency. As 
it is now, you have to press "FUNCTION" then "RIT," to activate XIT, tune 
the XIT to the same frequency as the RIT (which frequency has to be 
remembered because there is but one RIT/XIT readout available), then start 
sending. This takes way too long.

	In the category of "if wishes were horses," it would be great to have a 
"REVERSE" button as on the OMNIs that makes it possible to listen in on the 
second VFO's frequency and change that frequency while keeping the button 
pressed.

	All in all, though, a fine radio.

73,
John, W3ULS