[SMCARA] UV-5R programming

[KG3BOZ]

Turn the "Tone Squelch" to "OFF" or set it to "146.2"

Boz

-----Original Message-----
From: SMCARA [mailto:smcara-bounces at mailman.qth.net] On Behalf Of Chris
Ordiway
Sent: Sunday, September 21, 2014 8:22 PM
To: smcara at mailman.qth.net
Subject: [SMCARA] UV-5R programming

Howdy all,

While my Wouxun HT is down I thought I'd try using my Baofeng UV-5R HT with
the repeater. I use the CHIRP software so programming is easy but I seem to
be missing something. I can receive fine but I can't hit the repeater, I'm
hoping that someone else's eyes might catch my mistake so I can get back on
the air. When I key the PTT I don't get the beep from the repeater. I'm
going to list the settings below that I get on the CHIRP software, some are
user defined and some are default. Any help or suggestions would be
appreciated. (I know, I know... stop using a cheap Chinese HT...)

Settings:
Frequency : 146.640000
Name : K3HKI
Tone Mode : Tone
Tone : 146.2
ToneSql : 88.5 (default)
Cross Mode : Tone-> Tone (default)
DTCS Code : 23 (default)
RX DTCS Code : 23 (default)
DTCS Pol : NN (default)
Duplex : - (negative)
Offset : 0.600000
Mode : FM
Power : High
Skip : (blank - default)
BCL : (enabled box not checked - default)

Thanks!
Chris - KC3DIG
______________________________________________________________
SMCARA mailing list
Home: http://mailman.qth.net/mailman/listinfo/smcara
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:SMCARA at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html Message
delivered to kg3boz at md.metrocast.net