[R-1051] Compatible Modules

[Dave Faria]

This is what i ended up doing on the radio yesterday.  It was VERY difficult to get the crystal selector motor out of the frame so I did two things.  I had just spun the motor to get it working again on the ohm meter and felt this was only a temporary fix so I took the brushes out and cleaned the motor commutator with 90% isopropyl alcohol and the brushes I very gently wiped with a Q tip.  The next thing I did is probably considered a sin against the 1051.  It was very difficult to remove the motor mounting plate with the motor from the crystal assembly without stressing the wiring so I took my dremel took and cut a slot in the motor mount.  Now I can slip the motor back into its approximate position w/o stressing any wiring and then slip the motor mount bk in and bolt the assembly back together with no problems.  I hate to make changes but I've got fat fingers and poor vision.  An old age thing.

 

Dave Faria

Austin, Tx    
 

> From: David_Wise at Phoenix.com
> To: r-1051 at mailman.qth.net
> Date: Thu, 20 Jun 2013 13:37:59 -0700
> Subject: Re: [R-1051] Compatible Modules
> 
> That's one of the problems I had too. One of the first. I had my radio sort of working in just a few days, but shaking out the rest took months. Don't pop out the champagne too quick and you'll be fine. Good luck, and keep us posted.
> 
> Dave
> 
> -----Original Message-----
> From: r-1051-bounces at mailman.qth.net [mailto:r-1051-bounces at mailman.qth.net] On Behalf Of Dave Faria
> Sent: Thursday, June 20, 2013 1:35 PM
> To: R-1051 Discussion Group
> Subject: Re: [R-1051] Compatible Modules
> 
> Thanks Dave. I just started to work abt 3 - 4 days ago. Hopefully the only problem is the one i've found so far. The A2A6A1 module motor is not operating in the 1mhz unit. Since it is not turning the rotary switch that changes the crystals for the different frequencies the 20vdc never comes on line and fires up the receiver. I've got the module out right now and the brushes in the motor read open on the ohm meter. I took the motor apart spun the motor shaft and they now show a resistance. that may be all that was needed - I hope. This radio had been siting in a shed for a LOOONNNGGG time. The schematics for this radio are terrible..... i guess because it was a hybrid and the people who prepared the manual were use to tubes.... Anyway thanks for the info. 
> 
> 
> > From: David_Wise at Phoenix.com
> > To: r-1051 at mailman.qth.net
> > Date: Thu, 20 Jun 2013 13:03:14 -0700
> > Subject: Re: [R-1051] Compatible Modules
> > 
> > Everything but the "six-pack". In fact, only part of the six-pack: I know the six-pack subframe and the 100cps Synthesizer are incompatible without some rewiring, maybe the Spectrum Generator too, but I'm sure the 1Mc, 100kc, and 1&10kc Synthesizers and the RF Translator are compatible.
> > 
> > But these radios have aged to the point where module-swapping had better not be your only tool. When I fixed my R-1051, I went over each module in detail, and found something like a dozen different problems, some of which only became apparent when I tried to align. It's in the archive.
> > 
> > Dave Wise
> > SWL in Hillsboro Oregon
> > 
> > -----Original Message-----
> > From: r-1051-bounces at mailman.qth.net [mailto:r-1051-bounces at mailman.qth.net] On Behalf Of Dave Faria
> > Sent: Thursday, June 20, 2013 12:26 PM
> > To: r-1051 at mailman.qth.net
> > Subject: [R-1051] Compatable Modules
> > 
> > I have a 1051 non B unit I want to restore. Will any of the B modules work
> > in the 1051 non B.
> > 
> > Thanks 
> > Dave Faria WA5TEZ
> > 
> > ______________________________________________________________
> > R-1051 mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/r-1051
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:R-1051 at mailman.qth.net
> > 
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> > ______________________________________________________________
> > R-1051 mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/r-1051
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:R-1051 at mailman.qth.net
> > 
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> 
> ______________________________________________________________
> R-1051 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-1051
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-1051 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
> ______________________________________________________________
> R-1051 mailing list
> Home: http://mailman.qth.net/mailman/listinfo/r-1051
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:R-1051 at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html