[Premium-Rx] Help with WJ-8711 and WJ-8712 switches A2S1 and A2S2

[Steve Pappin via Premium-Rx]

Mike,

Your switch settings are correct. Be sure that your com ports are set to 
default. Typically the serial connection is DB-25 (radio) to DB-15 
(Computer). The wiring is 2 to 2, 3 to 3, and 7 to 5 respectively. Do not 
connect any other wires.

Best Regards,
Steve

----- Original Message ----- 
From: "Mike Tubby" <mike at tubby.org>
To: <Premium-Rx at mailman.qth.net>
Sent: Tuesday, December 16, 2014 3:00 PM
Subject: [Premium-Rx] Help with WJ-8711 and WJ-8712 switches A2S1 and A2S2


> All,
>
> I have two WJ-8711-1 and two WJ-8712-1 radios.
>
> I've just spent the evening fixing them (various minor faults) and trying 
> to get RCS32 (3.06.00) to talk to them with no luck, I can't get ERGO-4 to 
> talk to them either.
>
> I have all the switches on A2S1 "up" and all the switches on A2S2 "up" --  
> is that the correct setting for RS232 (not CSMA) at 9600 baud?
>
> I assume that the 25-way D-type is wired as a DCE, i.e.:
>
>     Pin 2 (TXD) is an input
>     Pin 3 (RXD) is an output
>     Pin 7 (GND) is ground
>
> ... anything else I need to know?
>
> Mike G8TIC
>
>
> ______________________________________________________________
> Premium-Rx mailing list
> Home: http://mailman.qth.net/mailman/listinfo/premium-rx
> Help Page: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Premium-Rx at mailman.qth.net
> Help Contact eMail:  paul at 8zo.com
> Home Page:  http://www.premium-rx.org/ 


---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com