[Milsurplus] Attaching cable to MS connectors

[J. Forster]

Not to nit-pick Gene, but you rarely have that much lead length between
the connector and the cable jacket start.

As to haemostats as a heat sink, that works fine on Teflon insulated wire,
but vinyl wire will get permanently smooshed and leave bare wire.

Best,

-John

==========


> Here's one I did.
>
> http://www.w2hx.com/x/URT-23/1310-cables/
>
> The first few pix are of a DB25, not an MS. But then there is the MS cable
> I made. Had about 19 wires connected. I do use heat shrink as you will
> see. I push the tube up as far as I can, often using some tape to hold it
> away from the connection. I also often use a hemostat on the wire between
> the solder joint and the heat shrink tube to help sink some of the heat.
> I've never had a problem with this technique.
>
>
> 73 Eugene W2HX
>
> -----Original Message-----
> From: milsurplus-bounces at mailman.qth.net
> [mailto:milsurplus-bounces at mailman.qth.net] On Behalf Of J. Forster
> Sent: Thursday, October 18, 2012 8:28 AM
> To: wrcromwell at gmail.com
> Cc: milsurplus at mailman.qth.net
> Subject: Re: [Milsurplus] Attaching cable to MS connectors
>
> It helps to lay out all the parts on the table in the order they are to be
> assembled, and check against the print.
>
> And second the use of non-shrink tubing. Either varnished Cambric or
> Teflon work well. Vinyl can be used, but it's trickier.
>
> -John
>
> ================
>
>
>> Hey...
>>
>> Make sure any collars, rings, threaded parts are not slipped on wrong
>> side to! I did THAT *once*.
>>
>> 73,
>>
>> Bill  KU8H
>>
>>
>> On Wed, 2012-10-17 at 23:01 -0400, COURYHOUSE at aol.com wrote:
>>> never forget the   threaded collar....    did that  once....  ONLY
>>> ONCE!
>>>
>>> Ed#
>>>
>>>
>>
>>
>> ______________________________________________________________
>> Milsurplus mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Milsurplus at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net Please help support this email
>> list: http://www.qsl.net/donate.html
>>
>>
>
>
> ______________________________________________________________
> Milsurplus mailing list
> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
> ______________________________________________________________
> Milsurplus mailing list
> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>