[LogPlus] logging with packet

Mon, 07 Jan 2002 22:18:00 -0500

Hello Glenn,

Sometimes you have to "force" the interface between radio and computer
in the LOGGING WITH PACKET mode.  Try the following keystrokes: CTRL_F1
(do this twice if RADIO ON shows in the top center of your monitor so
RADIO ON shows again).  This will bring up the FREQUENCY but sometimes
not the MODE. Changing to another MODE or BAND then back again gets the
MODE working OK and you are all set.  Hope this helps.

73, Grant
N4GM

[email protected] wrote:
> 
> Help ....
> 
>   While in the logging without packet window; the frequencey and mode info
> is picked
> up from my FT1000MP and displayed properly....
> 
> However when I go to the logging with packet (where the telnet spots are
> working ok);
> the frequency and mode boxes are empty. When I place a call in the callsign
> field and
> then hit "enter" to tab over., it jumps to the rst field. It will not allow
> me to place any
> info in the freq/mode boxes. Is there a turn on command so the logging with
> packet
> window will display the info from the FT1000MP ??   (using Ver 4.09 at
> present)
> 
> Thanks for any help..  Glenn VA3DX              [email protected]
> 
> _______________________________________________
> LogPlus mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logplus