[Logic] SERIAL PORT ERROR?

[Lloyd S. Smith]

Hi Bob:

Whenever I have a problem with any program the first place I look is the
registry.  Enter a search command for the word "logic" and delete every
entry that looks like it might have something to do with your problem. I fix
9 out of 10 problems this way.  I upgraded from 6 to 7 and have no problem
interfacing my FT1000MP.  You might also try searching for "com1"

73'  Lloyd
NX4W

----- Original Message ----- 
From: "k0dan" <k0dan at comcast.net>
To: "Robert Carroll" <rlcarroll at patmedia.net>;
<logic-bounces at mailman.qth.net>; <logic at mailman.qth.net>;
<dennis at hosenose.com>
Sent: Saturday, September 11, 2004 12:53 AM
Subject: Re: [Logic] SERIAL PORT ERROR?


> Hi Bob...
>
> Well, the short story is "no joy" and I am copying Dennis with this
message
> thread in hopes of help.
>
> Tonight I did the following:
>
> 1. Unintsalled Logic7 then ran LOGIC6, same serial timeout error.
> 2. Uninstalled COM1. Reboot. Same.
> 3. System Restore back to August, prior to install of LOGIC7. Same.
> 4. Power up PC first, then rig; then vice versa, no change.
> 5. Disconnect serial cable, reboot. Reconnect serial cable. Reboot. Same
> 6. Undo the Syetm Restore. Run LOGIC6. No change.
>
> So...no magic.
>
> While I have no reason to suspect them, this process did not test the rig
> interface (FT1000MP), the serial cable, or the PC's serial card. So I will
> test those as variables in the error, and will contact Dennis when I can
> swear the problem's not my hardware.
>
> Will keep you posted.
>
> 73
> Dan
> K0DAN
>
> ----- Original Message ----- 
> From: "Robert Carroll" <rlcarroll at patmedia.net>
> To: "'k0dan'" <k0dan at comcast.net>
> Sent: Friday, September 10, 2004 14:07
> Subject: RE: [Logic] SERIAL PORT ERROR?
>
>