[Logic] Spot Log

Mon, 19 Jan 2004 09:58:25 -0600

Very true Mel and thanks for that comment. I always reset those 
frequency ranges and put in a segment of each band for rtty. I realize 
they won't be totally accurate because they are part of the cw band but 
by so doing it at least alerts me to the fact that it MIGHT be a rtty 
station and I need more countries there than any other mode.

  --
73,
Chris, AC�M

Mel Martin wrote:

> Just to clarify a little... it sets the DEFAULT mode by frequency range...
> many digital spots specify the mode... which is important.
> 
> But an unspecified mode spot, at 7045 for example, could be just about
> anything... so you can't always rely on the spot mode being correct.
> Troublesome ranges are 1825-1835, 3600-3700, 7020-7150, 14050-14115 etc... I
> think the low end of 40M is the band where it is hardest to "guess" the
> mode.
> 
> ----- Original Message ----- 
> From: "C.M. Christensen" <[email protected]>
> To: <[email protected]>
> Sent: Monday, January 19, 2004 08:30
> Subject: Re: [Logic] Spot Log
> 
> 
> 
>>Hi Julio,
>>
>>Sure thing -- In order for Logic to properly spot the bands, modes, and
>>awards you are interested in seeing on the Spot Log you first have to go
>>into Tools/Setup/Bands and configure each band segment of each band for
>>what you want to see. In other words, for every band, or segment of a
>>band, put in the frequencies and modes that you want the Spot Log to
>>report. Then look at the key on the right side of the screen to
>>determine for which awards you want reports, such as DXCC, CQZ, etc.,
>>and either input or remove the proper numbers in each box according to
>>what you want the Spot Log to report. Be sure you check the box that
>>says Process spots for this band.
>>
>>  This all takes a bit of time and it is easy to get confused (like I
>>did, hi) so it is best to also open the Browse window that corresponds
>>to the report. If it is is not open just click the icon that is second
>>from last on the lower right corner of the Band table screen.
>>
>>When you are finished close the Band table and it will prompt you to do
>>and Awards Update. This must be done.
>>
>>Good luck.
>>-- 
>>73,
>>Chris, AC�M
>>
>>
>>Julio Peralta wrote:
>>
>>>Chris I don't think I understand about Set Modes. Can you give me a
> 
> little
> 
>>>more info.
>>>
>>>Julio, W4HY
>>
>>
>>
>>_______________________________________________
>>LOGic mailing list
>>[email protected]
>>http://mailman.qth.net/mailman/listinfo/logic
> 
> 
> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
> 