[Logic] Spot Log

[Julio Peralta]

Thanks Chris.  I understand the setup of spot log. It just didn't ring a
bell when I 1st read your message.

Julio, W4HY
----- Original Message ----- 
From: "C.M. Christensen" <cchrisac0m@cox.net>
To: <logic@mailman.qth.net>
Sent: Monday, January 19, 2004 8:30 AM
Subject: Re: [Logic] Spot Log


> Hi Julio,
>
> Sure thing -- In order for Logic to properly spot the bands, modes, and
> awards you are interested in seeing on the Spot Log you first have to go
> into Tools/Setup/Bands and configure each band segment of each band for
> what you want to see. In other words, for every band, or segment of a
> band, put in the frequencies and modes that you want the Spot Log to
> report. Then look at the key on the right side of the screen to
> determine for which awards you want reports, such as DXCC, CQZ, etc.,
> and either input or remove the proper numbers in each box according to
> what you want the Spot Log to report. Be sure you check the box that
> says Process spots for this band.
>
>   This all takes a bit of time and it is easy to get confused (like I
> did, hi) so it is best to also open the Browse window that corresponds
> to the report. If it is is not open just click the icon that is second
> from last on the lower right corner of the Band table screen.
>
> When you are finished close the Band table and it will prompt you to do
> and Awards Update. This must be done.
>
> Good luck.
> -- 
> 73,
> Chris, AC�M
>
>
> Julio Peralta wrote:
> > Chris I don't think I understand about Set Modes. Can you give me a
little
> > more info.
> >
> > Julio, W4HY
>
>
>
> _______________________________________________
> LOGic mailing list
> LOGic@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic
>