[Logic] Default signal reports on QSL cards/labels

Wed, 14 May 2003 06:43:47 -0700

Alan

Probably the easiest way is to set the default signal report in the QSO when
you log it, then overwrite it if it is different than 59.  On the log form
go to LOG, SETUP, and on the General page check the box for "Default RST to
59".

Terry,WQ7A

----- Original Message ----- 
From: "Allen R. Brier" <[email protected]>
To: <[email protected]>
Sent: Tuesday, May 13, 2003 11:53 PM
Subject: [Logic] Default signal reports on QSL cards/labels

> I would like to set a default signal report of 59 or 599 (depending on
> mode) on QSL cards and labels. Most contest QSO's have no signal report
> transferred to LOGic, so when printing cards or labels, the report field
> is blank. How do I do this?
>
> Allen R. Brier N5XZ N.I.C.E.T. IV Fire Alarm Systems
> BriTech Systems Incorporated
> 2018 Old Dixie Drive
> Richmond, Texas 77469-6811
> 281.342.1590
> 281.342.0940 (FAX)
> 713.705.4801 (Cell Phone/Voice Mail/Pager)
> [email protected]
> [email protected]
>
>
>
>
> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>