[Logic] Byte Runner Serial card

Sun, 9 Mar 2003 07:49:02 -0600

Paul,

I use the byterunner 4 port serial card in my XP system.

To find out which port corresponds to which connector, go to Device Manager,
and look under VScom Multi IO cards.  Double click on your card.  A
properties window will appear.  Click on the Advanced tab, the window shows
the mapping of the connectors to your serial ports.

For all of this to work, you should have installed the XP drivers.  They are
available from the Byterunner web site.  I believe there is a driver for the
card itself, then a driver for each serial port.  Easy to install.

73 de Ron  N�AT

----- Original Message -----
From: "Paul R" <[email protected]>
To: <[email protected]>
Sent: Sunday, March 09, 2003 04:05
Subject: [Logic] Byte Runner Serial card

> Howdy,
>
> My Windows XP is recognising my 4 additional serial ports but I cannot get
> them to work at all with Logic (rig or rotor control).
>
> I am trying to inteface both an FT1000mp and Kenwood Ts2000.
>
> Can someone email there settings for these Byterunner boards so I can lick
> this problem.
>
> I note the cable that connects to the Byterunner board has 4 serial
> connectors marked 1,2,3 and 4. I assume these are com 3, 4 , 5 and 6 in my
> computer (in that order).
>
> Any info is appreciated
>
> Cheers
>
> Paul (vk3ajj)
>
> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic