[Logic] Byte Runner Serial card

Sun, 9 Mar 2003 08:06:01 -0600

Paul:

Go to device manager and see how XP has assigned com ports.  I have a 4 port
card that starts with com 4 through 7, com 3 was skipped.  Com1 and Com2 are
on board the mother board.

Since your saying that xp is recognizing your card and all four ports I
would suggest that you are connecting to the correct port.  My card has a
pig tail arrangement with 4 db9 connectors.  I had a dickens of a time
hooking up to the correct port as the db9 cables are black and it was
difficult to read the number on the cable.

Not sure if that helps, GL.

----- Original Message -----
From: "Paul R" <[email protected]>
To: <[email protected]>
Sent: Sunday, March 09, 2003 4:05 AM
Subject: [Logic] Byte Runner Serial card

> Howdy,
>
> My Windows XP is recognising my 4 additional serial ports but I cannot get
> them to work at all with Logic (rig or rotor control).
>
> I am trying to inteface both an FT1000mp and Kenwood Ts2000.
>
> Can someone email there settings for these Byterunner boards so I can lick
> this problem.
>
> I note the cable that connects to the Byterunner board has 4 serial
> connectors marked 1,2,3 and 4. I assume these are com 3, 4 , 5 and 6 in my
> computer (in that order).
>
> Any info is appreciated
>
> Cheers
>
> Paul (vk3ajj)
>
> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>