[Logic] Byte Runner Serial card

[Dave Sublette]

Paul,

There are no settings associated with the Byterunner card. I am using 
Windows98, Second Edition. My computer has two serial ports on the 
motherboard, Com1 and Com2, a virtual serial port for an internal dialup 
modem, Com3, and recognizes my Byterunner card as Com5,Com6,Com7, and 
Com8. The Byterunner uses one IRQ...I forget which one.

I have three rigs and two rotators running on LOGic6.

There may be a driver issue with your Windows XP. I cannot say anything 
about XP, since I've never used it and don't know anything about it.

If you can get to you System resources table..on Windows98 it is Start, 
Settings, Control Panel, System. perhaps you can see what is happening.


I am now at the limit of my knowledge on theis subject..good luck.

Dave, K4TO

Paul R wrote:

> Howdy,
>
> My Windows XP is recognising my 4 additional serial ports but I cannot 
> get them to work at all with Logic (rig or rotor control).
>
> I am trying to inteface both an FT1000mp and Kenwood Ts2000.
>
> Can someone email there settings for these Byterunner boards so I can 
> lick this problem.
>
> I note the cable that connects to the Byterunner board has 4 serial 
> connectors marked 1,2,3 and 4. I assume these are com 3, 4 , 5 and 6 
> in my computer (in that order).
>
> Any info is appreciated
>
> Cheers
>
> Paul (vk3ajj)
>
> _______________________________________________
> LOGic mailing list
> LOGic@mailman.qth.net
> http://mailman.qth.net/mailman/listinfo/logic
>
>