[Logic] QSX Radio frequency

Sat, 23 Mar 2002 09:02:15 -0800

On some radios, Icoms come to mind, the TX VFO frequency cannot be read by
the computer unless it is made the active VFO.

Ben
----- Original Message -----
From: "Jim Brannigan" <[email protected]>
To: <[email protected]>
Sent: Saturday, March 23, 2002 08:54
Subject: Re: [Logic] QSX Radio frequency

> A note to OMNI-VI+ users.
> I find that if I set the split from the radio, Logic6 will not log the
Xmt.
> Freq.
> If I set the split from the log window, the Xmt. freq. is logged and the
> packet QSX is sent.
> This is a problem with the Ten Tec software.
> Jim
>
> > Hi
> > The split Frequency  works Fine for me and automatically on my
> > Kenwood 950 SDX that is connected to the computer via com 1 via Kenwood
> > interface IF-232C
> > In other words if your radio is connected to the computer and logic can
> > control it  the split frequency works automatically
> >
> > 73 Eli  4z5is
> >
> > Stern Eli  Advocate & Notary
> > ham radio callsign    4Z5 IS
> > ____________________________________
> > [email protected]                  OFFICE
> >
> > Haberman Dovev & Stern advocates & notarie  Office
> > 51 Wizman St Tel Aviv Israel
> > FAX  00972 3 6962206
> >
> > [email protected]           HOME
> >
> > 2 sagie st P.O.BOX 728   Reut ISRAEL 71908
> > Fax  00 972 8 9710010
> >
> >
> >
> > -----Original Message-----
> > From: [email protected] [mailto:[email protected]]
> > On Behalf Of GilBaronW0MN
> > Sent: Saturday, March 23, 2002 3:14 PM
> > To: AA/Logic
> > Subject: [Logic] QSX Radio frequency
> >
> > In the log form there is a field for transmit frequency when operating
> > split. Is there a way to automatically update this field to the exact
> > transmitted frequency as read from the rig rather than nothing or
> > offset?
> > I would like the program to read the other vfo and enter the frequency
> > here.
> > It would make sending spots so much more useful. On clusters if you have
> > QSX
> > (XMIT FREQ) then the spot logs will show this and logic users and others
> > that have the feature can set the split automatically. Since the set rig
> > automatically sets the split if on the spot log, that  means it has
> > access
> > to the other vfo. I assume there should be a way to read it also. Is
> > there a
> > way to do that or do you have to manually enter this field?
> >
> >
> > Gil Baron http://webpages.charter.net/gbaron
> > 44.08208 N 92.51263 W 1055'
> > "Hierro candente, batir de repente"
> >
> >
> > _______________________________________________
> > LOGic mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/logic
> >
> > _______________________________________________
> > LOGic mailing list
> > [email protected]
> > http://mailman.qth.net/mailman/listinfo/logic
>
> _______________________________________________
> LOGic mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/logic
>