[Kenwood] Adjusting the TS-940

[Bill VanOrden K7BVO]

I will bare my soul and plead ignorance.

 

Looking through the manual on user adjustments I come to the part where you
adjust the digital VFO display.

 

I'll paraphrase the section as it's a PDF document

 

MODE to CW and zero-beat to WWV at either 5,10 or 15MHz

 

Turn on the 100kHz calibrator, if the calibrator is not zero-beat with the
WWV signal, adjust the Standard Oscillator trimmer

 

Every reference to zero-beating I have found so far on the web revolves
around keying the transmitter,  you obviously can't do this in this instance
as it is a blocked frequency and competing with WWV is not stylish.  I
truthfully am not sure what I should be listening for.

 

This is my first HF rig where I had to prepare to transmit, so I am in
unfamiliar territory.  I know I am transmitting about 2kHz low from a friend
in town's report when we actually tested on the air.

 

Anyone have a good link or two or want to point me in the direction I need
to go?

 

Beevo (aka Bill VanOrden)  K7BVO

CONFIDENTIALITY NOTICE     Attention: This email is intended for the sole
use of the intended recipient(s) and may contain confidential or privileged
information. No one is authorized to copy or re-use this email or any
information contained in it. If you are not the intended recipient, we
request that you please notify us by reply email and destroy all copies of
the message and any attachments.   Thank you for your cooperation.