SV: [Kenwood] ts-440

Wed, 10 Mar 2004 00:36:31 +0100

Hi,
I think you find a mod to set RF-power-output in SSB mode with
the CAR-control
knob without touching micgainsetting at the danish site.
73
Rolf sm0cls=20

-----Ursprungligt meddelande-----
Fr=E5n: [email protected]
[mailto:[email protected]] F=F6r GGLL
Skickat: den 10 mars 2004 00:13
Till: Kenwood
=C4mne: Re: [Kenwood] ts-440

    Hello Gerald, there are many ways; I do not work psk (it
works into the mic audio chain, isn't it?), so one way could be
turning mic gain down to desired level. Another, permanent way
for ALL modes, is to trim the internal power output setting VR,
and by last there's an internal jumper or switch to set power
output to 50 watts maximum, also for ALL modes (this I think
intended to the Japan sell models).
 Both are under the Filter unit cover on the bottom of the rig.

Good luck
Guillermo - LU8EYW.

gerald bishop escribi=F3:

>Hi- Trying to help a friend out. How do you turn the power
out-put down=20
>on a TS-440?? Want to cut it in half for PSK. Only referance is
for=20
>setting up a linear- says to cut it down half-way. No mention as
to=20
>where-what. TKS,Jerry
>
>--- StripMime Report -- processed MIME parts ---
multipart/alternative
>  text/plain (text body -- kept)
>  text/html
>The reason this message is shown is because the post was in HTML
or had=20
>an attachment.  Attachments are not allowed.  To learn how to
post in=20
>Plain-Text go to: http://www.expita.com/nomime.html  ---
>- - -
>
>Your moderator for this list is:
>Larry Wilson KE1HZ [email protected]
>
>_______________________________________________
>Kenwood mailing list
>[email protected]
>http://mailman.qth.net/mailman/listinfo/kenwood
>
>
> =20
>
- - -

Your moderator for this list is:
Larry Wilson KE1HZ [email protected]

_______________________________________________
Kenwood mailing list
[email protected]
http://mailman.qth.net/mailman/listinfo/kenwood