[ICOM] IC-756ProIII: Meter adjustment menu Was: increase tuning power to 20 Watts?

[Alex]

Well, that mystery is solved. When they say terminate, they do mean 
terminate. :) A mono 3.5mm jack with a 10 ohm resistor soldered from the 
tip to ground did the trick. This will allow me to get into the 
adjustment mode following the instructions in the service manual. I was 
also able to increase the output power to 20 Watts for tuning using an 
external tuner.

73,
--Alex KR1ST


On 2015-12-04 18:07, Alex wrote:
> It looks as if it can be set through the meter adjustment menu. Per
> the service manual, I put a 3.5mm plug in the remote jack and then I
> hold the SSB and CW/RTTY buttons down while powering on the PIII, but
> the adjustment menu does not appear. Has anyone ever successfully
> accessed this menu? Perhaps I'm overlooking something.
> 
> 73,
> --Alex KR1ST
> 
> 
> On 2015-12-04 15:33, Alex wrote:
>> Hi there,
>> 
>> Does anyone know how to increase the power output of an IC-756ProIII,
>> while it is in tuning mode with an external tuner using the tuner
>> interface, from 8-10 Watts to 20 Watts?
>> 
>> 783,
>> --Alex KR1ST
>> 
>> ----
>> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
>> Icom Users Net: Sundays, 1700Z, 14.316 MHz
>> Icom FAQ: http://www.qsl.net/icom/
>> To support QSL/QTH.net: http://www.qsl.net/donate.html
> 
> ----
> Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/
> To support QSL/QTH.net: http://www.qsl.net/donate.html