[ICOM] IC-765 Question

[H. Dave Meitzen]

1. Running into 50 ohm load Tuner on or off - Power out remains the same in
to Array Solutions Power Master II. Coax connection 2'
2. Internal power supply PS35. Voltage is same on all bands 13.6VDC. Current
declined consistent with output.
3. PO on the 765 consistent with what I read on the PM II.
4. Looks like the drive declines at 20M to 10M - Output is 60W at 20M and
30W at 10M

Thanks\
Dave
-----Original Message-----
From: icom-bounces at mailman.qth.net [mailto:icom-bounces at mailman.qth.net] On
Behalf Of Larry Young
Sent: Sunday, April 14, 2013 12:09 PM
To: ICOM Reflector
Subject: Re: [ICOM] IC-765 Question

There are several questions that require an answer first. Is the built in
antenna tuner turned off and in bypass mode? Is your external wattmeter that
you are using for your measurements accurate thru 10 meters, and is it
located at or near the RF output connector of your 765? Is the DC power
supply that you are using rated for the required DC current and not going
into current limit at the higher bands? Is the DC voltage supplied to the
765 actually 13.8 volts when measured at the DC input of the rig at full
current load? these are all things that could affect the accuracy of RF
output power.
Larry K4LXV

--- On Sun, 4/14/13, H. Dave Meitzen <dmeitzen at tx.rr.com> wrote:

From: H. Dave Meitzen <dmeitzen at tx.rr.com>
Subject: [ICOM] IC-765 Question
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Date: Sunday, April 14, 2013, 12:39 PM

160M to 40M the output is 100 watts are better. 20M and up progressively
lower output 60 watts to 40watts on 10M.

Any recommendations where to start to look?

Thanks
Dave

----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/ To
support QSL/QTH.net: http://www.qsl.net/donate.html
----
Your Moderator: Dick Flanagan K7VC: icom-owner at mailman.qth.net Icom Users
Net: Sundays, 1700Z, 14.316 MHz Icom FAQ: http://www.qsl.net/icom/ To
support QSL/QTH.net: http://www.qsl.net/donate.html